Elevator2Flaps are set per flightmode
>
Elevator2Ailerons are set per flightmode
>
Choice for Elevator Up, Down or both sides mix, per flightmode.
This allows to only have the flaps and/or ailerons applied with elevator up, down or both directions.
>
Choice for applying the commong limiters per flightmode. You can activate the common limiters to apply a deadband and a rate limt.
This allows snapflap to be inactive for small elevator movements (deadband) and limited to a certain elevator defelction (rate limiter).
>
Set common deadBandLimit value. Elevator input below this value will be ignored. Value in percentage of elevator travel, no matter what rates setting is used
>
Set common rateLimit value. ELevator input beyond that level will be ignored, and set tpo the max level. Again, expressed in maximum elevator deflection, not in stick deflections.